Clean the IR LEDs and lens: Wipe away any dust or dirt from the IR LEDs and the lens.Adjust IR intensity: Increase the IR intensity in the camera’s settings for
Hikvision Cameras - World's Leading CCTV Manufacturer
Clean the IR LEDs and lens: Wipe away any dust or dirt from the IR LEDs and the lens.Adjust IR intensity: Increase the IR intensity in the camera’s settings for
Use the ConfigTool: Download and open the ConfigTool on a computer connected to the same network as the camera. Select the camera: Find your camera in the ConfigTool list. Assign
Check for a built-in microphone: Confirm that the camera has an integrated microphone or that an external one is connected. Enable audio recording: In the camera’s web interface, navigate to
Access the NVR’s interface: Log in to the NVR using a connected monitor or via the web interface. Go to “Camera Management”: Navigate to the section where cameras are added
Set up port forwarding: Configure port forwarding on your router for the camera’s IP address and relevant ports. Use the DMSS app: Download the DMSS app and add your camera
Check power supply: Ensure the camera is powered on and receiving power. Verify connections: Confirm that all video and power cables are securely connected to the DVR/NVR. Inspect camera status
Download the latest firmware: Obtain the latest firmware from the Dahua website. Access the camera’s web interface: Log in to the camera’s web interface using its IP address. Navigate to
Check recording schedule: Ensure the camera is set to record continuously or based on motion detection. Verify storage: Check if the hard drive or SD card has sufficient space and
Log in to the camera’s web interface: Use the camera’s IP address to access its configuration page. Go to “Event” settings: Navigate to “Event” > “Video Detection.” Enable motion detection:
Formatting the SD card manually via the web interface of the camera Open the web interface of the camera. Proceed to Setup → Storage → Destination → Local tab. Choose