Use Chrome/Edge With the IE Tab Extension (Recommended) 1. Install IE Tab Open Chrome or Edge. Go to the Chrome Web Store → search “IE

What You’ll Need Hikvision NVR (older firmware, e.g. 3.3.x or 4.x.x) Hikvision IP camera (unactivated) Windows PC with SADP Tool installed Ethernet cables ⚙️ Step

PART 1: Enable Smart Event (Line Crossing Detection) via NVR Local UI ✅ Step 1: Log in to the NVR (monitor connected to NVR) Use

Check network bandwidth: Ensure your network can handle the data stream from the camera, especially if multiple cameras are in use. Adjust camera settings: Lower

Use the SADP tool: Download and open the SADP tool on a computer connected to the same network as the camera. Select the camera: Choose

Check for a built-in microphone: Ensure the camera has an integrated microphone or an external one connected. Enable audio settings: In the camera’s web interface,

Enable port forwarding: Set up port forwarding on your router for the camera’s IP address and ports (e.g., HTTP, RTSP). Use Hik-Connect app: Download the

Clean the camera lens: Use a soft, lint-free cloth to clean any dirt or smudges from the lens. Adjust the focus manually: If the camera

Log in to the camera’s web interface: Use the camera’s IP address to access its web interface. Go to “Event” settings: Navigate to “Configuration” >

Check recording schedule: Ensure the camera is set to record continuously or on motion detection. Verify storage availability: Check if the hard drive has sufficient

Download the latest firmware: Visit the Hikvision website and find the latest firmware for your camera model. Access the camera’s web interface: Log in to

Check power supply: Ensure the camera is powered on and receiving adequate power. Verify video connections: Check that video cables (BNC or Ethernet) are properly

Step by step to reset your Hikvision camera: Locate the Reset button on the camera (this is under the SD card slot of most cams)

Question: How can I view my Hikvision cameras on a PC? Answer: Viewing your Hikvision cameras on a PC can be done using Hikvision’s software

If the IP camera and NVR are both new, then Hikvision’s cams and NVR will automatically active in most cases, this is becuase the NVR

Step-by-Step Guide to Reset a Hikvision Camera via the Reset Button Step 1: Locate the Reset Button Identify the Reset Button: The reset button is

You may wish to adjust your mainstream / substream framerates to make changes to the recording time. eg. if 20fps is giving you 30 days,

Accessing the Camera via the NVR’s Web Interface Access the NVR’s Web Interface: Open a web browser on a computer connected to the same network