Product SKU: PNM-C12083RVD
Product Overview
Wide-area monitoring at building corners, entry points, and perimeter transitions usually demands multiple cameras, multiple cable runs, and multiple VMS licences. The Hanwha Wisenet PNM-C12083RV addresses this directly by mounting two independent 6MP sensors into a single outdoor housing, each with a motorised varifocal lens spanning 3.54 to 6.69mm, adjustable remotely to frame each viewing direction precisely. Both channels are processed through on-board AI that classifies persons, faces, vehicles, and licence plates in real time, embedding metadata into the video stream so a compatible VMS can perform forensic searches without additional processing hardware. WiseNRII reduces image blur in low-light conditions, and IR illumination extends to 25m per channel. The housing carries IP66, IK10, and NEMA4X ratings, making it suitable for exposed outdoor positions in demanding environments. A single PoE+ connection powers the entire unit, and edge recording via microSD of up to 512GB provides a local backup layer.
Key Capabilities
Dual 6MP Sensors, Single Mount
Two independent 1/2.8″ CMOS sensors deliver 3328 x 1872 resolution per channel from one mounting point. This reduces cabling, conduit penetrations, and installation time at corners or intersections where two viewing directions would otherwise require separate cameras.
Remote Motorised Varifocal Optics
Each lens covers 3.54 to 6.69mm with a 78-degree tilt range and can be adjusted independently via software after installation. This allows the installer or integrator to dial in the framing for each channel without physical lens access, reducing revisit time on elevated or difficult mounts.
On-Board AI Object Classification
Deep-learning algorithms classify persons, faces, vehicles, and licence plates directly on the camera. Metadata is embedded in the video stream, enabling compatible VMS platforms to run fast forensic searches across recorded footage using object type as a filter rather than scrubbing through raw video.
120dB Extreme WDR with WiseNRII
Extreme Wide Dynamic Range at 120dB handles scenes with simultaneous bright and dark zones, such as covered entry points or car park exits. WiseNRII applies AI-based noise reduction in low light, producing cleaner images where standard noise reduction would introduce blurring or artefacts.
IP66, IK10, NEMA4X Outdoor Housing
The housing is rated for full dust exclusion and water jet resistance, withstands IK10 impact loads, and meets NEMA4X standards for corrosion resistance. This combination suits exposed coastal, industrial, or high-traffic mounting positions where weather and deliberate interference are genuine risks.
Single VMS Licence for Two Channels
A compatible VMS treats the PNM-C12083RV as a single device regardless of its dual channels, meaning only one camera licence is consumed at the management platform level. On large deployments with per-channel licensing, this can represent a significant ongoing cost saving compared to running two separate cameras.
Best For
- Building Corners and Entry Points: The dual-sensor design covers two approach directions simultaneously from a single bracket or junction box position, making corners at car parks, logistics yards, and commercial campuses efficient mounting candidates.
- Sites with VMS Licence Cost Pressure: Because a compatible VMS consumes only one licence for both channels, the PNM-C12083RV is well suited to deployments where per-channel licence costs are a meaningful budget consideration.
- Licence Plate and Vehicle Identification Zones: On-board AI classifies vehicles and licence plates in real time with BestShot capture, making it appropriate for entry lanes, boom gate approaches, or loading dock access points where vehicle identification is a primary requirement.
- Exposed Industrial and Commercial Locations: The IK10 vandal rating, IP66 sealing, NEMA4X corrosion resistance, and operating range of -40°C to +55°C suit it for outdoor industrial sites, ports, and facilities exposed to harsh conditions year-round.
- Forensic Search Deployments: Integrators building systems where operators need to search recorded footage by object type benefit from the embedded AI metadata and BestShot functionality, which reduces review time without requiring server-side analytics licences.
Why Choose the PNM-C12083RV
The PNM-C12083RV is not simply two cameras sharing a housing. Each sensor has its own independently adjustable motorised varifocal lens, its own IR illumination path, and its own AI processing stream, yet the entire unit draws power from a single PoE+ drop and consumes one VMS licence on compatible platforms. A standard single-sensor camera cannot replicate the angular coverage or the forensic metadata workflow this camera provides without doubling the hardware, cabling, and licensing overhead. The confirmed FIPS 140-2 cybersecurity compliance and WiseStreamIII compression add further value in enterprise and government environments where cybersecurity policies and bandwidth constraints apply. For integrators and end users looking at multi-directional coverage with genuine on-board intelligence rather than basic motion-triggered recording, the PNM-C12083RV, available at Security Wholesalers, represents a well-specified option at the professional end of the Hanwha Wisenet range.
Buyer Tip – PoE+ Requirement: The PNM-C12083RV requires PoE+ (IEEE 802.3at, Class 4) to operate. Standard PoE (802.3af) switches will not deliver sufficient power. Confirm that your switch or injector supports at least 30W per port before ordering. If your existing switch is standard PoE only, a mid-span PoE+ injector will be required for each camera position.
Buyer Tip – Frame Rate Expectation at 6MP: The maximum frame rate for each channel at full 6MP resolution is 15fps. For most perimeter, entry, and forensic identification applications this is sufficient. If your use case requires 25 or 30fps at high resolution, such as fast-moving production line or sports venue monitoring, review whether a different sensor specification is more appropriate before committing to this model.
Key Features & Technical Specifications
| Model |
Hanwha Wisenet PNM-C12083RV |
| SKU |
PNM-C12083RVD |
| Sensor |
1/2.8″ CMOS progressive scan x 2 channels |
| Resolution |
6MP x 2 (3328 x 1872 per channel) |
| Maximum Frame Rate |
15fps at 6MP per channel |
| Lens |
3.54-6.69mm motorised varifocal, fixed iris, 78-degree tilt angle |
| Minimum Illumination (Colour) |
0.16 Lux (F1.67, 1/30sec, 30IRE) |
| Minimum Illumination (B/W) |
0.016 Lux (F1.67, 1/30sec, 30IRE); 0 Lux with IR on |
| IR Range |
Up to 25m per channel |
| Day/Night |
Auto ICR (true day/night) |
| Wide Dynamic Range |
Extreme WDR 120dB |
| Video Compression |
H.265, H.264, MJPEG; WiseStreamIII |
| AI Analytics |
Person, Face, Vehicle, Licence Plate classification; BestShot; virtual line crossing; area intrusion/exit; loitering; directional movement; appear/disappear; audio analytics; tampering |
| Network |
RJ-45 10/100/1000 Base-T Ethernet |
| Power |
PoE+ (IEEE 802.3at, Class 4) |
| Local Storage |
microSD, up to 512GB |
| Ingress Protection |
IP66, IK10, NEMA4X |
| Operating Temperature |
-40°C to +55°C |
| Cybersecurity |
FIPS 140-2 compliant |
| Noise Reduction |
WiseNRII (AI-based) |
Ideal Use Cases
Car Park Entry and Exit Lanes
The AI licence plate classification and BestShot capture make this camera well suited to vehicle identification at boom gate approaches or open entry lanes. One unit can simultaneously cover inbound and outbound lanes where mounting positions are limited.
Commercial Campus Perimeters
At the corners of fenced commercial campuses or industrial yards, the dual-sensor design covers two fence lines or approach paths from a single pole or wall mount, reducing the total camera count and associated infrastructure across large perimeters.
Retail and Shopping Centre Concourses
Area intrusion, loitering detection, and person classification run on-board, allowing a VMS to trigger alerts without server-side processing. In wide concourse intersections, two independently framed channels can cover foot traffic from different directions at the same mounting point.
Logistics and Warehouse Loading Docks
The IP66, IK10, and NEMA4X ratings, combined with the -40°C to +55°C operating range, make this camera appropriate for loading dock environments where dust, temperature extremes, and physical impact risks are all present simultaneously.
Enterprise and Government Sites
FIPS 140-2 cybersecurity compliance supports deployment in environments where government or enterprise IT security policies require verified encryption standards. WiseStreamIII compression helps manage bandwidth budgets on large-scale network infrastructure.
Choosing the Right Model
- Choose this model if: You need to cover two distinct viewing directions from a single mounting point, require on-board AI classification with embedded metadata for VMS forensic search, and want to reduce per-camera licensing costs on a compatible platform. The confirmed IP66, IK10, and NEMA4X ratings also make it the right choice where housing durability in harsh outdoor environments is non-negotiable.
- Choose a different model if: Your primary requirement is a single wide-angle view rather than two separately aimed channels, as a fisheye or wide-angle panoramic camera may give broader coverage in a single flat plane without the need for independent channel aiming. If continuous 25 or 30fps capture at full resolution is essential to your application, a different sensor configuration will be required as this model is rated to 15fps at 6MP per channel.
- Choose a different model if: Your existing switch infrastructure is standard PoE only and mid-span injectors are not practical. The PoE+ (802.3at) power requirement is fixed and cannot be met by 802.3af switches without additional hardware.
FAQs
- How does the dual-channel design work at the VMS level?
On a compatible VMS, the PNM-C12083RV is registered as a single device and consumes one camera licence regardless of the two active video channels. Both streams are managed through one connection, and AI metadata from each channel is available to the VMS for forensic search and alert generation without requiring separate licence entries for each sensor.
- Can each lens be aimed independently after installation?
Yes. Both motorised varifocal lenses (3.54-6.69mm) can be adjusted remotely via software once the camera is installed and connected. The 78-degree tilt range per channel means the installer can set the physical orientation on the bracket during mounting and then fine-tune the horizontal and vertical framing for each sensor from the management interface without returning to the camera.
- What does BestShot do in practice?
When the AI detects an object such as a person or vehicle, BestShot captures and stores a representative frame of that object at the moment of detection. In a VMS forensic search, BestShot images appear alongside search results, allowing operators to visually identify the specific person or vehicle in a result set before reviewing the full video clip. This significantly reduces the time spent reviewing footage during investigations.
- Is the camera suitable for mounting in a coastal or chemically exposed environment?
The NEMA4X rating specifically addresses resistance to corrosion from external agents including salt air and mild chemicals, in addition to the IP66 water jet and dust protection. For coastal installations or facilities with chemical exposure risk, the NEMA4X certification confirms the housing is designed for those conditions. Operating temperature tolerance down to -40°C also covers cold-climate outdoor positions.
- What licence plate detection capability does the on-board AI provide?
The AI on the PNM-C12083RV classifies licence plates as an object category and embeds this metadata into the video stream. This enables a compatible VMS to search recorded footage by licence plate as a filter. Full ANPR with character-level plate reading depends on the VMS platform and the configured field of view. The camera’s role is object classification and metadata generation, not standalone ANPR output.
- Does the PNM-C12083RV require a specific switch port configuration?
The camera requires PoE+ on the connecting switch port, which is IEEE 802.3at Class 4. Standard PoE (802.3af) ports do not supply sufficient power for this unit. The Ethernet interface is 10/100/1000 Base-T, so a Gigabit PoE+ port is the appropriate connection. Confirm your switch specification before deployment. Security Wholesalers can assist with compatible switch recommendations if required.
- How much local storage can the camera hold, and is edge recording automatic?
The built-in microSD slot supports cards up to 512GB. Edge recording behaviour, including whether it operates continuously, on motion, or as a failover when the network connection is interrupted, is configured through the camera’s web interface or VMS. Using a high-endurance microSD card rated for continuous write cycles is recommended for applications where the card will be written to frequently.
Additional Information
